Cal Flame BBQ08953P Spécifications télécharger pdf (Page 9)

Top Gun Barbecue Grill

LTR50001121, Rev. B

Built-in Construction

www. ca l a me b bq . c o m

Connect the last open line to the side burner

(Use gas rated tape seal on all connections)

Then take other end of "T" adapter with hose attached

and connect to end of male located underneath and at

the back of the grill. (Use gas rated tape seal on all

connections).

Open barbecue door. Install hose with regulator on propane

tank. Then connect other end to "T" adapter. Make sure to

use gas rated tape seal when installing adapter to insure

proper seal.

Grill

Items Included with Barbecue

1) "T" adapter, 3/8"

2) 2 hose fittings, 3/8”

3) Regulator with hose

NOTE: You will need to use a gas rated

sealer on gas connectors that are not flared.

To Propane Tank

3/8" Fittings

From Grill

From Side Burner

"T" adapter, 3/8" Threaded

To side burner, located

underneath behind burner.

To grill, located

underneath and

behind grill

GAS LINE

Assemble a 3/8” pipe nipple to the 1.

3/8” pipe tee using Te on tape or

pipe sealant. Use only sealant that is

approved for use on LP gas.

Install the pipe tee assembly to the 2.

grill intake pipe. Tighten assembly

and align the branch opening of the

tee with the hole of the cabinet.

Connect the  exible hose (male end) 3.

to the pipe tee.

Install the side burner into the island 4.

by simply setting it in place.

Connect the female end of the  exible 5.

hose to the side burner intake pipe.

Connect gas supply to the grill.6.

Check for gas leaks using soap water 7.

solution.

Your Cal Flame grill must be plugged into a

permanent, grounded 110V outlet with a dedicated

15A GFCI breaker in accordance with local codes or

the National Electrical Code, ANSI / NFPA 70,

or the Canadian Electrical Code, CSA C22.1.

It is the owner’s responsibility to ensure that the

electrical connection to this appliance is properly

installed. We recommend a contractor or licensed

electrician install a dedicated 110V electrical service

for your grill.

Do not use an extension cord to supply power to

your Cal Flame grill. Such use may result in  re,

electrical shock or other personal injury.

Do not install a fuse in the neutral or ground circuit.

A fuse in the neutral or ground circuit may result in

an electrical shock hazard.

Do not ground this appliance to a gas supply pipe or

hot water pipe.

Use copper wire only. The use of aluminum wire may

result in unsatisfactory connections.

Install 120VAC, 15 Amp duplex outlet in an accessible

location under the grill inside the base enclosure.

Locate the electrical supply box inside the built-in

enclosure within reach of the power cord so the

connection is accessible when the grill is completely

installed in the enclosure.