Cal Flame B-200 Instructions d'exploitation télécharger pdf (Page 21)

Safety and Operating inStructiOnS

5-17

0056-1351

4. Re-tighten the screw.

5. Freeplay will automatically be obtained; this allows approximately ¼-inch movement

at the extreme end of the throw-out lever.

SCREW

THROW-OUT

LEVER

CLUTCH SHAFT

ASSEMBLY

CLUTCH

YOKE

SHAFT

ROLL PIN

1. LOOSEN SCEW

2. PRESS LEVER

DOWN, HOLDING

CLUTCH SHAFT

ASSEMBLY CAM

AGAINST ROLL PIN

3. TIGHTEN SCREW

Figure 7: Drive Clutch Adjustment

5.05 CUTTING MACHINE REPAIR

Remove the inner case from the outer case when making major repairs to the cutting machine.

This is not necessary for minor work such as lubrication or clutch adjustment.

A. Inner Case Removal

Perform the following steps:

1. Unplug the power cord.

2. Remove the rack handle assembly.

3. Remove the clutch control levers from each end of the machine.

4. Remove the SPEED knobs from each end of the machine. A ﬂat washer and two (2)

spring washers are provided under each SPEED knob.

5. Remove one end plate, which is held by two button head socket screws.

6. Remove the four socket head cap screws that have their heads counter-bored into

the top of the outer case. These screws secure the inner case.

7. Turn the machine upside down. Loosen the caster locking knobs a few turns to clear

groove in caster, then remove casters.

8. Remove the bottom cover, which is held by six slotted head screws.

Machine Maintenance

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 39 40

Pas de commentaire

Cal Flame B-200 Instructions d'exploitation Page 21