Cal Flame B-200 Instructions d'exploitation télécharger pdf (Page 22)

5-18

Safety and Operating inStructiOnS

0056-1351

WARNING

Unplug the power cord before performing any maintenance. Whenever the bottom

cover of the machine is removed, short out the capacitor. Capacitors hold an

electrical charge even after the power cord has been disconnected. Touch an

insulated screwdriver (plastic or rubber handle) across the capacitor terminals

under the rubber boot. Hold the screwdriver by the insulated handle.

9. Lift the inner case assembly from the outer case. Place it beside the outer case with

the wires still connected.

10. Remove inner case cover and gasket which are secured by seven slotted head

screws.

11. Reverse procedures for reassembly. When reassembling the SPEED knobs, apply

enough pressure to the SPEED knob to ﬂatten the spring washers and hold while

tightening the set screws.

B. Rear Axle Removal

1. Remove the inner case from the outer case. (See Page 17)

2. Remove the drive wheel and the key from each end of the axle.

3. Remove the retaining ring at the end of the spring. Remove the ring by inserting a

screwdriver under the ring and twist the screwdriver to pry the ring off the axle.

4. Remove the bushing on the end of the axle toward the motor.

5. Slide the axle and spring partway through the bushing hole. Remove the spring and

the two (2) remaining retaining rings.

6. Slide the axle through the bushing hole and out of the clutch dog and drive gear.

7. Reverse this procedure for reassembly.

C. Transfer Shaft Removal

1. Remove the inner case from the outer case. (See Page 17)

2. Remove the capacitor which is held by two screws and a clamp.

3. Remove the retaining ring.

4. Remove the transfer shaft by sliding the entire assembly out of the inner case through

the bearing mounting hole.

NOTE

The center bearing is captured on the transfer shaft and is not available

separately.

D. Cone Disk,Output Disk and Worm Shaft Removal

1. Remove the inner case from the outer case. (See Page 17)

2. Remove the retaining rings and washers from both ends of the speed adjusting shaft.

Machine Maintenance

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 39 40

Pas de commentaire

Cal Flame B-200 Instructions d'exploitation Page 22